PSP is intended for drying wet sand.
Technical details
Performance
up to 150-180 kg/hour
Agitator shaft diameter
257 mm
Rotation frequency
20 rev/min
Electric motor power
2,2 kW/hour
Power of heating elements 9 х 1 kW
9 kW
Equipment
PSP
1pcs
Dry sand container
1pcs
Sieve classifier
1pcs
Real passport
1pcs
Dimensions
Length - 3300 mm
Width - 720 mm
Height - 1190 mm
The weight - 440 kg
Device and principle of operation
1. Frame
2. Reducer 1Ts2U160
3. Receiving hopper
4. Cylindrical heat chamber
5. Agitator shaft
6. Steam taps
7. Heating elements
8. Thermal insulation
9. Electrical control cabinet
10. Sieve classifier
11. Container for dry sand
El motor 2.2 kW
The work of the PSP is as follows – in 30 minutes before the start of the work, the heating elements are turned on to warm up the cylindrical thermo camera. After warming it up, the electric motor is switched on, which, through a belt drive to the gearbox, makes the agitator shaft move.
Then, the sand is poured through the receiving hopper, which is distributed by the agitator shaft through the cylindrical thermo camera. Moisture is removed during the drying process through two steam outlets. After drying the agitator shaft moves the sand to the outlet, where it falls on the classifier sieve, with subsequent unloading into the storage container.
Our contacts